Ad

Tuesday, August 13, 2013

Powerwheels RC conversion


I soon noticed my 20 month daughter affinity to vehicles. I wanted to give her one where she could sit and enjoy the ride, but currently most powered vehicles for infants require they are able to reach the throttle pedal and properly handle the steering wheel. So I figured out the best way would be to go remote controlled. As I already had done previous projects involving RC gear, it would be piece of cake to turn a regular electric car into a large scale RC car where a small kid could sit inside.

Thursday, May 2, 2013

Power Supply Refactoring - finishing the details


In spite of already being a working device, there were aspects that like I explained in the previous post, required some attention. One of the major fixes was the voltage drift. This was caused by the 5 K potentiometer used to set the voltage end point. It was too large (the sweet spot of my setup was around 500 Ohms), which besides making it difficult to adjust, caused temperature induced resistance drift to be too large, causing an increase of around 200 mV from the initial voltage once the temperature settled.

Sunday, April 28, 2013

Power Supply Refactoring - closing the hood

After many hours of work I finally can say it's done. Even though I don't consider it the perfect work, I can definitively consider it a major improvement in respect to the previous version of the PSU:

Before:


Tuesday, April 16, 2013

Power Supply Refactoring - part 5

Prior to assembling the definitive power supply circuit board (i.e. the main electronics featuring the LM723) I took the time to set it up on a breadboard. Before that I finished the board containing only the large components such as the filter capacitors and the high wattage resistors (current shunt used by the regulator chip to sense the current across the power rail, and a bleed resistor for the output capacitor):


Sunday, April 7, 2013

Power Supply Refactoring - part 4

Another weekend have passed, and along with it a few more results as I slowly but steadily walk towards completion of the project. The digital voltmeter/ammeter displays have still not arrived from China. This is the last piece of hardware missing. Adding time to the equation and all the elements necessary to complete the project are available.

Friday, April 5, 2013

Power Supply Refactoring - part 3

Bit by bit the work is advancing. I have finally defined the schematic diagram from the entire power supply circuit. It includes also the PIC based fan control.